Buy Low Price From Here Now
10 Pc Diamond Hole Saw Set, Sizes: 1/4, 3/8, 1/2, 3/4 and 1 on 1/4 Shank.Sizes: 1.1/4,1.3/8, 1.1/2, 2, 2.3/8 on a 3/8 Shank., Comes in a Wooden Box.
Readmore
Technical Details
- 10 Pc Diamond Hole Saw Set- Sizes: 1/4, 3/8, 1/2, 3/4 and 1 on 1/4 Shank.
- Sizes: 1.1/4,1.3/8, 1.1/2, 2, 2.3/8 on a 3/8 Shank.
- Comes in a Wooden Box.
- Made In China
See more technical details
By Amateur Tiler (Florida)
All I can say is the diamond hole saws were exactly what I needed. I have only used 3 of the saws. The ones that I used were on porcelain tile and they provided a nice clean finish. I had to make a template out of wood to place on top of the tiles to keep the saw from skipping. But, that did the trick and it helped hold in a little water as well.
By Rebecca
I cut three holes each with two of the saw bits. They cut the holes thru 1/2 in granite. The cutting edge showed considerable wear with just the three cuts. I got what I wanted from them in the short term, but I doubt they would be acceptable for everyday/extended use
By D. Sargent (New England)
I bought this hole saw set because it was an unbelievable price and I trusted the reviews. I was not disappointed. One name brand professional bit can easily cost what this entire set costs! My first test was to cut a hole in a granite kitchen counter top. It did so flawlessly.
As another reviewer wrote, the hole saws do not come w/centering bits (some of the bits are too small for centering bits anyway). This is easily overcome (as the same reviewer wrote) by making a template out of plywood (Use a wood bit to pre drill a hole of equal size in the plywood). I used two sided tape to stick the plywood to the granite and a sponge to keep the bit wet and soak up the slop.
I don't think the bits will last forever cutting granite (for the price I would have never expected them to) and they bottom out at about 1-3/8", but it is certainly nice to have a pretty varied assortment of bits that you can trust to make accurate holes in stone or tile.
By William T. Moore (Oregon)
I used the drills to make a hole in Travertine tiles and used a V shaped board to help center the drill, since it does not have a pilot drill. It worked great, better than what I had expected.
By R. Heisler (Jackson, NJ)
I used the 1 1/2in size to enlarge the hole in my granite counter top to accommodate a new hot water tap that replaced a soap dispenser. I first cut a 1 1/2in hole in a piece of plywood, taped it to the counter that drilled away while my wife sprayed cold water at the bit to keep it cutting smooth. All and all I would say the bit worked very good, great for the money.
Images Product
Buy SE Diamond Hole Saws 1/4" - 2 3/8" Now
0 comments:
Post a Comment